General Parameters

The general debugging and diagnostic parameters are described in the table below.

General Debugging and Diagnostic Parameters

Parameter

Description

'Delay After Reset [sec]'

configure voip > sip-definition advanced-settings > delay-after-reset

[GWAppDelayTime]

Defines the time interval (in seconds) that the device's operation is delayed after a restart.

The valid range is 0 to 45. The default is 7 seconds.

Note: This feature helps overcome connection problems caused by some LAN routers or IP configuration parameters' modifications by a DHCP server.

configure system > hw > dual-powersupply-supported

[DualPowerSupplySupported]

Enables the device to send an SNMP alarm (acPowerSupplyAlarm) for one or both Power Supply modules if a module is removed from the chassis or not operating correctly (failure).

■ [1] = (Default) Disable. The alarm is applicable only to the main Power Supply module (#1). The device sends the alarm if this module is removed from the chassis or fails. The alarm is not sent for the secondary Power Supply module (#2) even if it is removed or fails.
■ [2] = Enable. The alarm is applicable to both Power Supply modules. If any of the modules are removed or fail, the device sends the alarm, indicating the affected module.

Note:

■ For the parameter to take effect, a device restart is required.
■ If configured to [2], make sure that the device is installed with two Power Supply modules. If only one module is installed, the device will send an alarm indicating a removed module.
■ If you want to use only one Power Supply module for the device, make sure that the parameter is configured to [1]; otherwise, an alarm will be raised indicating a removed module.

[HighTemperatureThreshold]

Defines the temperature threshold around (sensors) the device's CPU that if exceeded, an SNMP alarm (acBoardTemperatureAlarm) is sent. The alarm indicates the temperature sensor(s) that measured the exceeded threshold and the temperature itself. For more information, refer to the document SBC-Gateway Series SNMP Alarm Reference Guide.

The default is 70°C (158°F).

[EnableAutoRAITransmitBER]

Enables the device to send a remote alarm indication (RAI) when the bit error rate (BER) is greater than 0.001.

■ [0] = Disable (default)
■ [1] = Enable